Router 4G Systems XSBox Go

Here you find how to configure and reset 4G Systems XSBox Go Router.

4G Systems XSBox Go

Preconfigured wireless settings

SSID:
starts with XSBoxGO_
Password:
<blank>

Accessing your router's configuration interface

To connect to your router's web interface, follow these steps:

  1. Turn on router
  2. Connect the device via Wi-Fi* with the router
  3. Open browser
  4. Enter IP address or URL in the address line and confirm with ‘Enter’ button
  5. Enter password in the open user interface and confirm again

Reset 4G Systems XSBox Go router to factory defaults

To reset the 4G Systems XSBox Go to its default settings, you have to do the following steps:

  1. Put router into operation
  2. Press R button and hold for at least 4 seconds
  3. Device restarts automatically
  4. Router has been reset to factory settings

The unit will reboot automatically. Once the power light stops blinking, the unit has been reset and is ready to use. Resetting the router does not reset the firmware to an earlier version, but it will change all settings back to factory defaults.

4G Systems XSBox Go Router Security

Change 4G Systems XSBox Go Default Wifi Name (SSID)

Rename your 4G Systems XSBox Go Default Wifi Name (SSID). Some 4G Systems routers come with default network names (with the name of the manufacturer). We recommend to use a different name because a default name unnecessarily identifies the make of your router, making it easier for attackers to break in.

Change 4G Systems XSBox Go Default Password

It’s easy for a hacker to find out the manufacturer’s default password for your 4G Systems XSBox Go router and then use that password to access your wireless network. So it’s wise to change the administrator password for your 4G Systems XSBox Go router. When you’re deciding on your new password, try to pick a complex series of numbers and letters and try to avoid using a password that can be guessed easily.

MAC Address filtering for 4G Systems XSBox Go router

MAC filtering allows you to limit access to your 4G Systems XSBox Go router. To enable this feature, enter into your 4G Systems XSBox Go router the 12-character MAC ID of each computer that will connect to your network. Be sure to update this information if you add or remove devices.

Disabling Broadcast SSID for 4G Systems XSBox Go router

4G Systems XSBox Go router transmits your Wi-Fi network ID (the so-called SSID) to everyone. This may be changed at will by unchecking the corresponding box in the settings. Then your network will not be so easily hacked. However, as a compromise, you will have to enter the SSID every time that you connect a device to the network. This step is not mandatory.

MAC Address filtering for 4G Systems XSBox Go router

MAC filtering allows you to limit access to your 4G Systems XSBox Go router. To enable this feature, enter into your 4G Systems XSBox Go router the 12-character MAC ID of each computer that will connect to your network. Be sure to update this information if you add or remove devices.

Where are you placing the 4G Systems XSBox Go router in the house?

You wouldn’t think about this at first, but where you place your 4G Systems XSBox Go also has a bearing on your security.

Place the 4G Systems XSBox Go router as close as possible to the middle of your house. The first benefit is that all the rooms in your house have the same access to the Internet. The second benefit is that you don’t want to have your wireless signal range reach too much outside your house, where it can be easily intercepted by cybercriminals.

For this reason, don’t place your 4G Systems XSBox Go router next to a window, since there’s nothing to obstruct the signal going outside your house.