Router D-Link DIR-450
Here you find how to configure and reset D-Link DIR-450 Router.

Login to D-Link DIR-450 Router
Open a web browser, such as Google Chrome, and enter the IP address of your router in the address bar.
Preconfigured wireless settings
Accessing your router's configuration interface
To connect to your router's web interface, follow these steps:
- Turn on router
- Establish a connection between the device and the router via network cable or Wi-Fi*
- Open web browser
- Enter IP address in the address bar and then confirm with ‘Enter’ key
- Enter username and password in the open interface and confirm once more
Reset D-Link DIR-450 router to factory defaults
To reset the D-Link DIR-450 to its default settings, you have to do the following steps:
- Turn on router
- Press Factory Reset button and hold for at least 15 seconds
- Device restarts automatically
- Default settings have been restored
The unit will reboot automatically. Once the power light stops blinking, the unit has been reset and is ready to use. Resetting the router does not reset the firmware to an earlier version, but it will change all settings back to factory defaults.
D-Link DIR-450 Router Security
Change D-Link DIR-450 Default Wifi Name (SSID)
Rename your D-Link DIR-450 Default Wifi Name (SSID). Some D-Link routers come with default network names (with the name of the manufacturer). We recommend to use a different name because a default name unnecessarily identifies the make of your router, making it easier for attackers to break in.
Change D-Link DIR-450 Default Password
It’s easy for a hacker to find out the manufacturer’s default password for your D-Link DIR-450 router and then use that password to access your wireless network. So it’s wise to change the administrator password for your D-Link DIR-450 router. When you’re deciding on your new password, try to pick a complex series of numbers and letters and try to avoid using a password that can be guessed easily.
MAC Address filtering for D-Link DIR-450 router
MAC filtering allows you to limit access to your D-Link DIR-450 router. To enable this feature, enter into your D-Link DIR-450 router the 12-character MAC ID of each computer that will connect to your network. Be sure to update this information if you add or remove devices.
Disabling Broadcast SSID for D-Link DIR-450 router
D-Link DIR-450 router transmits your Wi-Fi network ID (the so-called SSID) to everyone. This may be changed at will by unchecking the corresponding box in the settings. Then your network will not be so easily hacked. However, as a compromise, you will have to enter the SSID every time that you connect a device to the network. This step is not mandatory.
MAC Address filtering for D-Link DIR-450 router
MAC filtering allows you to limit access to your D-Link DIR-450 router. To enable this feature, enter into your D-Link DIR-450 router the 12-character MAC ID of each computer that will connect to your network. Be sure to update this information if you add or remove devices.
Where are you placing the D-Link DIR-450 router in the house?
You wouldn’t think about this at first, but where you place your D-Link DIR-450 also has a bearing on your security.
Place the D-Link DIR-450 router as close as possible to the middle of your house. The first benefit is that all the rooms in your house have the same access to the Internet. The second benefit is that you don’t want to have your wireless signal range reach too much outside your house, where it can be easily intercepted by cybercriminals.
For this reason, don’t place your D-Link DIR-450 router next to a window, since there’s nothing to obstruct the signal going outside your house.